![background image](http://html2.mh-extra.com/html/xerox/docuprint-4635/docuprint-4635_operators-manual_4072836065.webp)
3.
Paper facts
This chapter contains information about paper handling and
procedures for loading feeder trays and unloading stacker bins.
Important facts about paper
As the operator of the 4635 LPS printer, you need to be aware of
the importance of taking good care of the paper used in it.
Using the correct type of paper and taking time to store and
condition it properly helps to keep your printer running at
optimum speed and efficiency, with fewer time-wasting paper
jams.
For additional information about paper, refer to Helpful Facts
About Paper.
Paper storage
Follow these storage guidelines:
•
Do not unwrap the paper stock until it is needed.
•
Store the reams of paper in their carton.
•
Do not leave the paper cartons directly on the floor. Place
something beneath them, for example, wooden pallets.
•
When the paper stock is taken from a storage area with a
different humidity or temperature, keep it in the room where
it will be used for at least 48 hours before loading it into the
LPS.
Paper specifications
The following paper can be used in the 4635 LPS:
•
Paper sizes
— Width: 7 to 17 inches/178 to 432 mm (17 inch/178 mm
paper parallel to feed direction)
— Length: 10 to 14.33 inches/254 to 364 mm
A continuous range of paper sizes from the system
minimum to the system maximum is supported. Table
3-1 lists the standard paper sizes.
Note: 7 X 10 inch/178 by 254 mm paper can be fed with
the optional 7 X 10 enablement kit installed.
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
3-1