STATUS AND PRINT TASKS
Note: If the selection of the Units window is inches, enter
the dimensions in inches; if it is millimeters, enter the
dimensions in millimeters.
4. Select the appropriate header button:
•
Apply/Use. Apply your selection and close the window.
•
Apply. Apply your selection.
•
Close. Close the window.
Set Container Size task through
command line
Enter the following command:
SET CONTAINER container #,w,l
container #
The container you want to modify. (Refer to
Table 9-1 for information on Container
numbers.)
w
The new width in millimeters.
l
The new length in millimeters.
Note: You cannot enter inches in command line mode.
Bin full criteria and setting bin limits
Use this task to tell the printer when to consider a stacker bin
full, and when to switch to another bin.
You can request that bins continue to fill until:
•
A specific number of reams or sheets has been stacked
•
A specific report, report set, or print job is finished
•
A specific report, report set, or print job is finished after a
specific number of sheets has been stacked.
9-24
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
