SYSTEM CONTROL TASKS
•
Select the Disabled button to turn off the energy saver
mode.
•
Select the Enabled button to turn on the energy saver
mode.
2. If the Enabled button is selected, the Time Out Period
appears. Enter the number of minutes in the Time Out
Period field. The smallest number that can be entered is 10,
the largest is 65,535.
3. Select the appropriate header button:
•
Apply/Close. Apply your selection and close the window.
•
Apply. Apply your selection.
•
Close. Close the window.
Energy Saver task through
command line
To adjust the time-out period, enter the following command:
ENERGY [timeout]
timeout
The number of minutes after which the energy
saver mode begins. If you do not enter a value,
the current timeout value appears.
Set date/time
Use this task to set the system date and time. The system must
be idle when you perform this task. (Idle means not printing,
offline, and not performing any non-printing tasks.)
Notes:
•
You must be at logon level 2 to use this task.
•
The hours field is specified in military time, that is, 0—23,
with 0 signifying midnight.
Set Date/Time task through windows
1. Select “Set Date/Time” from the System Control menu to
open the Set Date/Time window.
Figure 4-13.
Set Date/Time window
Note: When you set the time backwards, the chronological
sequence of records in the console log is no longer valid.
Save and empty the console log. (Refer to the “Console log”
section, which follows.)
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
4-13
