BAR CODE OPERATING PROCEDURES
Turning bar code on or off
The 4635 LPS bar code feature may be activated either:
•
Through the Messages window of the PC UI
•
Through the system controller terminal
Turning bar code on/off through
windows
1. Open Job Control Menu at the System UI.
2. Open Bar Code Reader Control Window.
3. Select On, Off, or Alignment.
If you select Off, you may specify the number of pages
through which the bar code feature is to be deactivated.
Figure 14-1.
Bar Code window
Note: The Bar Code Reader Control Window is only available if
the system has the Bar Code Reader option installed.
Turning bar code on/off through
command line
Enter the following command:
BAR [{OFF[,n]/ON/ALI}]
OFF
Disables bar code processing. The job can still be run,
but no sequence verification will occur. Audit reports
will show all deliveries as being without sequence
numbers. The BAR OFF MODE continues until BAR ON
is entered.
n
This is an optional command indicating that the BAR OFF
condition will only continue for n image sides, or until
output encounters the end of report, whichever occurs
first.
The value of n can be in the range of 1 to 65534.
ON
Allows the resumption of bar code processing.
14-2
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
