Xerox Document Centre 420, User Manual

Page: 20 / 466

Page 1-8 Xerox Document Centre 440/432/430/426/425/420 User Guide
Use of an extension cord with this product is not
recommended or authorised.
Users should check building
codes and insurance requirements if a properly earthed
extension cord is to be used. Ensure that the total ampere
ratings of the products plugged into the extension cord do not
exceed the extension cord ampere rating. Also, make sure that
the total amperage of all products plugged into the wall outlets
does not exceed the outlet rating.
Disconnect Device for this product is the power cord. To
remove all electrical power to the product, disconnect the
power cord from the power receptacle.
Your equipment is equipped with an energy saving device to
conserve power when the machine is not in use. The machine
may be left on continuously.
Unplug this product from the wall outlet before cleaning.
Always use materials specifically designated for this product.
Use of other materials may result in poor performance and
could create a hazardous situation.
Do not use aerosol cleaners. Follow the instructions in this
User Guide for proper cleaning methods.
Never use supplies or cleaning materials for purposes other
than those for which they were intended. Keep all supplies and
materials out of reach of children.
Do not use this product near water, wet locations, or outdoors.
Do not place this product on an unstable cart, stand or table.
The product may fall, causing personal injury or serious
damage to the product
Slots and Openings in the cabinet and in the back and sides
of the product are provided for ventilation. To ensure reliable
operation of the product and to protect it from overheating,
these openings must not be blocked or covered. The product
should never be located near or over a radiator or heat register.
This product should not be placed in a built-in installation
unless proper ventilation is provided.
Never push objects of any kind into the slots of the product as
they may touch dangerous voltage points or short out parts
which could result in a fire or electric shock.
Never spill liquid of any kind on the product.