Error Code
403
P
rob
le
m Solving
14
027-530
O
[Cause] During the transfer using [SMB] of the [Scan to PC]
feature, a file could not be saved because [Cancel Job]
had been selected for [File Name Conflict].
[Remedy] Select any option other than [Cancel Job] for [File Name
Conflict].
027-531
O
[Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an error occurred because the filing policy was
invalid.
[Remedy] When selecting [Change Name and Save] in [File Name
Conflict], make sure that the file format is not Multi-Page.
027-532
O
[Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an error occurred when accessing to the
NEXTNAME.DAT file.
[Remedy] If [Change Name and Save] has been selected for [File
Name Conflict], check if the NEXTNAME.DAT file is
correct.
027-533
O
[Cause] During the transfer using [SMB] of the [Scan to PC]
feature, an internal error occurred.
[Remedy] Try executing the same operation. If the error persists,
contact our Customer Support Center.
027-543
O
[Cause] The SMB server (NetBIOS) name is invalid.
[Remedy] Check if the server name of the SMB server is correct.
027-547
O
O [Cause] SMB protocol error. An invalid character was detected in
the specified domain name.
[Remedy] If the error occurred during SMB authentication:
Check with the network administrator for the domain
name, then re-configure correctly.
Also, check if the domain name set on the machine is
correct, using the following procedure:
1. Enter the System Administration mode, and select
[Tools] > [System Settings] > [Connectivity & Network
Setup] > [Remote Authentication Server / Directory
Service] > [SMB Server Settings].
2. Select the SMB server to check the domain name.
If the error occurred during the transfer via SMB of [Scan
to PC]:
Check the domain name which has been specified when
entering login name with the network administrator. To
check the domain name on the server, take the following
procedure:
1. Select [Start] > [Programs] > [Administrative Tools] >
[Active Directory Domains and Trusts] on the Active
Directory domain controller.
2. From the left side frame of the [Active Directory
Domains and Trusts] window, select [Active Directory
Domains and Trusts] > [Domains]. Right-click [Domains]
to select [Properties].
3. Select [General] tab in the domain properties window,
check the domain name (prior to Windows 2000).
Error Code
Category
Cause and Remedy
C P F S M O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
