Connectivity & Network Setup
135
T
ools
5
Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
Adobe Communication Protocol
z
Standard
Select this when the communication protocol is in the ASCII format.
z
Binary
Select this when the communication protocol is in the binary format. Depending on the data,
the print job may be completed faster than when Normal is selected.
z
TBCP
Select this to switch between the specific control codes when the communication protocols
involve both ASCII and binary formats.
z
RAW
Select this when the communication protocol is in the RAW format.
If you cannot correctly print EPS files from a Macintosh computer via USB, select this option.
LPD
Port Status
Select [Enabled] to use LPD.
LPD Port Number
Select [Standard (515)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 515.
Important •
Do not use the numbers assigned to the other ports.
LPD Maximum Number of Sessions
Enter the maximum number of sessions. You can enter a number between 1 and 10 in 1
session increments.
The default value is 5.
NetWare
Port Status
Select [Enabled] to use NetWare.
SMB
Port Status
Select [Enabled] to use SMB when using Scan to PC (SMB) service or sharing the machine
on the network.
IPP
Port Status
Select [Enabled] to use IPP.
Set this when you want to use IPP (Internet Printing Protocol) to print via the Internet.
IPP - Added Port Number
Enter the port number for IPP except the standard port number in the range from 1 to 65535.
To disable this option, select [Disabled].
The default value is 80.
Important •
Do not use the numbers assigned to the other ports.
Note
•
You cannot select [IPP - Added Port Number], if IPP port is disabled.
Enable IPP port first and reboot the machine, and then configure [IPP - Added Port Number].
