Connectivity & Network Setup
143
T
ools
5
SMTP AUTH Password
Enter the password for verification purpose at the SMTP server. Up to 64 single-byte
characters are allowed.
Using the numeric keypad displayed by pressing [Keyboard], enter the same password in
[New Password/Passcode] and [Retype Password/Passcode]. If you do not set the
password, leave the text boxes blank and select [Save].
Domain Filtering
Set accepted domains. In [Domain Filtering], you can set the following items.
Domain Filtering
Select one from [Off], [Allow Domains], or [Block Domains].
Domain 1 - Domain 50
Specify up to 50 domains if either [Allow Domains] or [Block Domains] has been selected for
[Domain Filtering].
Using the numeric keypad displayed by pressing [Change Settings], up to 64 single-byte
characters are allowed.
Remote Authentication/Directory Service Settings
You can make the settings for the remote authentication server and Directory Service.
Authentication System Setup
Authentication System
Allows you to select the system for authentication from [Kerberos (Windows2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After the authentication system has been changed, personal mailboxes and personal job flow
sheets operated on the previous authentication system are not deleted automatically. If these
mailboxes or job flow sheets are no longer needed, delete them from the machine. If the
same user IDs are also used on the new authentication system, the personal mailboxes and
personal job flow sheets can be used by the same users.
Server Response Time-Out
Set the time-out value for a response from a server in the range of 1 to 75 seconds in 1
second increments.
Search Time-Out
Set the time-out value for user search on a server in the range of 1 to 120 seconds in 1
second increments.
Kerberos Server Settings
Configure the Kerberos Server 1 through 5.
The settings in [Kerberos Server 1] will be the default settings for authentication.
Primary Server Name/IP Address
Enter the primary server name or IP address.
Note
•
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
•
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
Primary Server Port Number
Set the Primary server port number in the range from 1 to 65535.
The default value is 88.
Important •
Do not use the numbers assigned to the other ports.
Secondary Server Name/IP Address
Enter the secondary server name or IP address.
