Vigilantplant TDLS8000, User Manual

Page: 67 / 320

<3. Installation, Wiring, Optical Axis Adjustment, and Piping>
3-22
IM 11Y01D01-01EN
• The required components and tools are shown below.
RJ45 modular plug
RJ45 modular plug crimp tool
LAN cable tester
Wire cutter
Wire stripper
Round crimp-on terminal
(for shielded wires)
For M4 screw
Use the appropriate crimp-on terminals for the Ethernet cable that you are
using.
Crimp-on terminal example:
For M4 screws, nominal cross sectional area of wire 2 mm
2
FV2-4 by J.S.T. Mfg. Co.,Ltd. or 170782-1 by TE Connectivity, or equivalent
Crimp tool for round crimp-on
terminals
Heat shrink tube Used to cover the shielded parts of the Ethernet cable.
Use the appropriate heat shrink tube for the Ethernet cable that you are using.
Heat shrink tube example:
For shielded wires: inner diameter 4 mm, length about 140 mm
For external cable covering: inner diameter 10 mm, length about 30 mm
Heating gun For shrinking heat shrink tubes
l
Processing an Ethernet cable
(1) Pass the Ethernet cable through the cable gland.
(2) Remove about 150 mm of covering from the shielded Ethernet cable.
Be careful not to cut off the shield.
Outer covering
Cable gland
About 150 mm
(3) Bundle the shield in a linear form, cover it with a heat shrink tube, and apply heat treatment
to shrink the tube.
Then, attach a round crimp-on terminal to the end of the shield.
Cover with a heat shrink tube the section of the cable where the covering was removed, and
apply heat treatment to shrink the tube.
Outer covering
Cover with a heat shrink tube, and apply heat
treatment to shrink the tube.
Then, attach a round crimp-on terminal to the end.
Bundle the shield in a linear form.
Cover with a heat shrink tube, and apply heat treatment to shrink the tube.
3rd Edition: Jun. 10, 2016-00