Vigilantplant TDLS8000, User Manual

Page: 57 / 320

<3. Installation, Wiring, Optical Axis Adjustment, and Piping>
3-12
IM 11Y01D01-01EN
n
TDLS8000 Wiring Terminals
CAUTION
Be careful not to connect the power supply wires to the incorrect locations or reverse the polarity.
In particular, incorrectly connecting the power supply terminals (POWER, VO, VO[HMI]) or
solenoid valve control output terminals (SV-1, 2) can damage the TDLS8000 or the devices
connected to the TDLS8000.
AO-1 AO-2 AI-1 AI-2 DI-1 DI-2 DO FAULT
+ - + - + - + - + - + -
NC COM NO NC COM
LC MS-1 MS-2 VO
+ - + - + - + -
LC MS-1 MS-2 VO SV-1 SV-2 POWER VO (HMI)
+ - + - + - + - + - + - + - + + - -
Isolated
4-20mA
Output
With
HART
4-20mA
Input for
Pressure
transmitter 4-20mA
Input for
Temperature
transmitter
Solenoid
Valve
Control for
Auto Cal
Digital
Output for
programmable
DO
Digital
Output for
FAULT
Power
Supply
24V DC
24V DC Output for
YH8000 Power
Isolated
4-20mA
Output
Solenoid
Valve
Control for
Auto Cal
Magnified Terminal A
Terminal A
Magnified Terminal B
Terminal B
Magnified Terminal C
Terminal C
Connect to shield wire terminal
(Both side of cable)
Digital Input
Sensor Control Unit (SCU) Laser Unit (LU)
Earth for shield wire
Earth terminal
Earth for shield wire
Earth terminal
Ethernet port for
YH8000 or DCS
Figure 3.12 TDLS8000 wiring
Table 3.1 Terminals and functions (laser unit: LU)
Terminal
block
Terminal
name
Function
A
NC Not used
LC+ Inter-unit communication, control signal, power supply
Connect these terminals to the terminals with the same names on
terminal block C in the SCU.
LC-
MS-1+
MS-1-
MS-2+
MS-2-
VO+
VO-
3rd Edition: Jun. 10, 2016-00