Vigilantplant TDLS8000, User Manual

Page: 213 / 320

<9. Inspection and Maintenance>
9-40
IM 11Y01D01-01EN
(3) Checking the calibration result
The span calibration result is displayed. Tap OK to return to the menu.
9.8.5 Consecutive Automatic Execution
It is possible to execute zero calibration and span calibration consecutively in automatic
execution or semi-automatic execution. It is also possible to execute offline validation
consecutively using check gas 1 and then check gas 2.
The combinations that can be executed consecutively are shown below.
• Zero calibration and span calibration (zero+span calibration)
• Offline validation 1 and offline validation 2 (offline validation 1+2)
To perform consecutive automatic execution, you need to make the following preparations.
Piping: Connect the piping so that both automatic calibration and validation can
be executed.
Configuration: Configure the automatic calibration and validation settings.
Automatic execution configuration: Refer to “9.8.2 Configuration”, and configure the
automatic execution settings.
The settings and detailed operation of each consecutive automatic execution are explained
below.
l
Zero+span calibration
Piping: Connect the piping for zero+span calibration provided in “9.5.1
Preparation”.
Configuration: Configure the zero calibration (see section 9.5.2) and span calibration
(see section 9.6.2).
Automatic execution configuration: Configure from the following menu as necessary.
[HART] “Detailed setup>>Calibration>>Zero+Span calibration”
[YH8000] “ >>Configuration>>Calibration>>Zero + Span Calibration”
Semi-automatic execution menu path:
[HART] (Cannot be executed from HART)
[YH8000] “ >>Execution>>Calibration>>Semi-Auto>>Zero + Span Calibration”
3rd Edition: Jun. 10, 2016-00