Vigilantplant TDLS8000, User Manual

Page: 6 / 320

v
IM 11Y01D01-01EN
CAUTION
Sufficiently understand this user’s manual and carry out the work carefully so as not to make a
mistake with a pipe or wire.
CAUTION
Electrostatic discharge
The TDLS8000 and YH8000 contains devices that can be damaged by electrostatic discharge.
When servicing this equipment, please observe proper procedures to prevent such damage.
Replacement components should be shipped in conductive packaging. Repair work should
be done at grounded workstations using grounded soldering irons and wrist straps to avoid
electrostatic discharge.
CAUTION
• Do not use an abrasive or organic solvent in cleaning the instrument.
CAUTION
Please turn off the power to the TDLS8000 befor remove the analyzer from process flange.
n
Maintenance by qualified engineer
Work carried out by other than a qualified engineer may cause injury to the worker and/or severe
damage to the equipment. Furthermore, if the warnings in this manual are not observed, the
worker may be seriously injured and/or the equipment may be severely damaged.
Maintenance of the equipment must be performed by a qualified engineer. Qualified engineer
refers to the following:
• Engineer who is familiar with how to safely handle process analyzers (or general automation
technology) and has read this manual and understood its content.
• Engineer who has received training on how to start and configure equipment and has read
this manual and understood its content.
n
Replacement of battery
The battery (CR2050 type) on the CPU board in TDLS8000 cannot be installed on site because it
must be mounted at the factory. If it needs replacing, contact a Yokogawa service center.
n
Transportation of products containing lithium batteries
TDLS8000 contains lithium batteries. Primary lithium batteries are regulated in transportation by
the U.S. Department of Transportation, and are also covered by the International Air Transport
Association (IATA), the International Civil Aviation Organization (ICAO), and the European
Ground Transportation of Dangerous Goods (ARD). It is the responsibility of the shipper to
ensure compliance with these or any other local requirements. Please consult the current
regulations and requirements regarding the transportation of lithium batteries before shipping.
3rd Edition: Jun. 10, 2016-00