Vigilantplant TDLS8000, User Manual

Page: 54 / 320

<3. Installation, Wiring, Optical Axis Adjustment, and Piping>
3-9
IM 11Y01D01-01EN
n
TDLS8000 Installation
CAUTION
The process window is where the laser beam passes through. Be careful not to damage or stain
the window during installation.
After mounting an alignment flange and the like to the process flange, install the TDLS8000
according to the following procedure.
(1) First fasten three M6 screws in the TDLS8000 mounting screw holes on the flange surface
of the alignment flange. Leave about 8 mm of gap from the flange surface. Do not fasten the
screw in the upper right hole as viewed from the front. The upper right screw is attached on
the TDLS8000 side.
(2) Insert the alignment flange screws that you fastened in (1) in the holes on the mounting
surface (quick connectors) of the laser unit (or sensor control unit), and then rotate the unit
clockwise.
(3) Temporarily fasten the upper right screw, and then tighten all screws evenly.
CAUTION
Carefully mount the laser unit (or sensor control unit) to prevent the O-ring from being damaged
or dropping out during assembly.
CAUTION
Anti-seizing grease is applied to the screw areas. Be careful to keep dust or the like from
adhering. If dust or the like adheres to the areas, remove the dust or the like, and then reapply
the anti-seizing grease.
Hole with a hexagonal hole
Quick connector
Alignment flange
Turn clockwise
Process flange
Figure 3.8 SCU or LU installation
3rd Edition: Jun. 10, 2016-00