245
-
Carefully inspect centering bushes, rubber pads, and silent block.
-
Replace worn components found to exhibit excessive play, resulting in unsatisfactory
riding characteristics.
-
For reassembly, perform these operations in the reverse order.
-
Apply TUTELA Z2 grease on all bearings and revolving components.
-
Complete the assembly tightening the nuts onto the relevant pins at the correct tightening
torques.
Tightening torques:
Swing arm bolt, engine side
45-50 lbs·ft
(
64-72 N·m
)
Swing arm bolt, frame side
53-58 lbs·ft
(
76-83 N·m
)
Silent-block - frame bracket screw
29-36 lbs·ft
(
42-52 N·m
)
Swing arm bolt,
23-29 lbs·ft
engine and frame side
(
33-41 N·m
)
11.15 Swing Arm Overhaul
-
Check that the silent-block is not broken.
Replace if necessary.
-
Remove the snap ring shown in the figure.
-
Remove the bracket and the silent-block.
-
Remove the silent-block ring shown in the
figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...