206
-
Check there are no signs of wear on the sealing
surface of the float needle, the softened pin or
the return spring.
-
If there are any signs of wear, replace the
needle with a new one.
-
Check that the float shows no signs of wear on the hinge, or the metal tab in contact with
the float needle and check that fuel has not infiltrated the float.
-
If there are any defects, replace the float with a new one.
-
Re-fit the float, together with the needle, inserting the pin from the fuel inlet side.
Note:
Ensure the return spring on the float tab is in the correct position.
10.11.9.2
Walbro WFV-7P Carburetor
-
Before reassembling the carburetor, carefully clean the carburetor body using fuel and
compressed air.
-
Take particular care in cleaning the fuel feed duct and the float valve seat.
-
In the Venturi tube check the air calibration,
shown in the figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
