164
-
Remove the two wrist pin spring clips, the wrist
pin and the piston.
-
Remove the piston rings.
Note:
Take care to avoid damaging the piston
rings whilst removing them.
10.10.16 Inspecting the Small End
-
Measure the internal diameter of the small end
using an internal micrometer.
Standard dimension:
Small end diameter
∅
0.5911-0.5915 in
(
15.015-15.025 mm
)
Max. allowable dimension:
Small end diameter
∅
0.5917 in
(
15.030 mm
)
Note:
Whenever the small end exceeds the wear
limit, or shows signs of wear or overheating,
replace the crankshaft with a new one, as
described in the following pages.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
