136
10.7.31
Removing the Driven Pulley Shaft
-
In order to remove the driven pulley shaft, its
bearing and oil seal, it is necessary to remove
the transmission cover and the clutch assembly
as previously described.
-
Pull the driven pulley shaft off the bearing.
-
Remove the oil seal from inside the bearing and
expel it on the transmission side taking care no
to damage its seat.
-
Remove the Snap ring shown in the figure.
-
Using the modular punch, remove the driven
pulley shaft bearing.
Specific equipment and tools:
Handle
020376Y
1.10
×
1.18 in (
28
×
30mm
) adapter
020375Y
0.78 in (
20mm
) guide
020363Y
10.7.32
Checking the Hub Cover
-
Ensure that the mating surface is not dented or distorted.
-
Check that the bearing housing shows no signs of wear or cracks.
-
If any defects are found, replace the hub cover.
10.7.33
Fitting the Hub Casing Bearings
-
Heat the engine crankcase and the hub cover
using the specific hot air gun.
Specific equipment and tools:
Hot air gun support
020150Y
Hot air gun
020151Y
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
