222
10.12.4
Fitting the Water Pump
-
Using the hot air gun, heat the flywheel cover
from the inside.
Specific tools and equipment:
Hot air gun
020151Y
Note:
To prevent damage to the painted surface,
avoid overheating the cover.
-
Place the flywheel cover on the ring-shaped
base as during the pump removal.
-
Position the bearing pair on the specific drift.
Note:
Always use new bearings. Use grease to
keep bearings on the specific tool.
-
Drive the bearing fully home into the crankcase
using a plastic mallet.
-
Assemble the ceramic ring with the rubber
gasket. The ceramic ring bevel must face the
gasket.
-
Lubricate the rubber gasket and fit the
assembly to the flywheel cover.
-
If necessary, use the drift from 020440Y only
by hand.
Note:
Always use new ceramic rings and gaskets.
Failure to manually install the ceramic ring may
damage the ring.
-
Insert the drive on the guiding pin of the
support base of the specific tool no. 020440Y.
Ensure that the convex side faces upwards.
Specific tools and equipment:
Punch
020440Y
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
