197
10.11.8.2
Walbro WVF-7P Carburetor
-
To disconnect the carburetor from the engine, it
is necessary to move the air filter and remove
the throttle cable, the automatic choke
connection, the clamps fastening the carburetor
to the filter box and the intake manifold, the
pipe supplying air to the membrane, and the
inlet connection.
-
Pull off the carburetor and rotate it to remove
the screw with the water connection complete
with pipes.
Note:
This operation is necessary to avoid
emptying the cooling system. It is also necessary
to disconnect the cut-off vacuum supply pipe.
-
Remove the protection, the clamp and the
automatic choke device after releasing the
screw shown in the figure.
-
Remove the clamp and the cap with the
membrane chamber filter.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
