181
10.10.36 Fitting the Thermostat
-
Place the thermostat with the drainage hole in
the highest point.
-
Check that the rubber gasket is properly
positioned.
-
Install the thermostat cover with the carburetor
heating connection facing the flywheel.
-
Tighten the two screws at the prescribed torque.
Tightening torque:
Thermostat screw
2.1-2.8 lbs·ft
(
3-4 N·m
)
10.10.37 Fitting the Intake Manifold
-
Install the intake manifold and tighten the three
fastening screws.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...