223
-
Fit the flywheel cover, complete with bearings,
onto the specific tool.
-
Fit the shaft, comp lete with the mechanical
seal, on the bearings.
-
Using the specific drift and the press, insert the
shaft into the bearings and the drive until the
specific tool is felt to have reached its abutting
end.
Note:
Carefully center the punch onto the
impeller. Apply force to the shaft and check that
the flywheel cover rotates horizontally. Failure to
observe this rule may result in damage to the
drive.
-
Refit the impeller cover using a new O-ring.
-
Tighten the three fixing screws at the
prescribed torque.
Tightening torque:
Impeller cover fixing screws
2.2-2.9 lbs·ft
(
3-4 N·m
)
Note:
Do not lubricate the O-ring. Failure to
observe this rule results in distortion to the ring.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
