160
10.10.10 Thermostat Removal
-
Loosen the two screws shown in the figure and
remove the thermostat cover.
-
Remove the thermostat and its gasket.
10.10.11 Removing the Timing Chain Sprockets
-
Before removing the cylinder head, it is
necessary to remove all of the following
components: transmission cover, driving pulley
(and belt), starter Bendix, oil sump with spring
and blow-by piston, lower oil pump sprocket
cover, O-ring on crankshaft and oil pump
sprockets-timing chain disk.
-
Remove the rocker cover.
-
Remove the central screw fastener and the
automatic valve-lifter retaining cover.
-
Remove the automatic valve-lifter cam, together
with its end-stop ring.
-
Loosen the central screw on the chain tensioner.
-
Remove the two screw fasteners shown in the
figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...