156
-
Check the rotor axial clearance using a rectified
bar as shown in the figure.
Max. allowable clearance:
Rotor axial clearance
0.0035 in
(
0.09 mm
)
10.10.6
Fitting the Oil Pump
-
Check that the pump shaft body is not worn.
-
Check that the pump cover exhibits no wear or
superficial imperfections.
-
If any measurement does not comply with the
limits previously specified or if any part is scored
or worn, replace the part or, if necessary, the
assembly.
-
Fit the pump cover in a position such to allow
the alignment of the holes for the screws
fastening the pump to the crankcase.
-
Tighten the fastening screws with specified
torque.
Tightening torques:
Oil pump-crankcase fixing screws 0.51-0.66 lbs·ft
(
0.7-0.9 N·m
)
-
Ensure that the gasket is correctly positioned
and then fit the pump to the crankcase. The
pump can only be fitted in one position. Tighten
the screws with the prescribed torque.
Tightening torques:
Oil pump fastening screws
3.7-4.4 lbs·ft
(
5-6 N·m
)
-
Fit the pinion with a new O-ring.
-
Fit the chain.
-
Fit the pulley, the central screw, and the
Belleville washer. Tighten with the prescribed
torque.
Tightening torques:
Central screw
7.4-10.3 lbs·ft
(
10-14 N·m
)
-
Fit the pump cover and tighten the two screws
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
