189
-
Fit the oil filter union and tighten it to the
specified tightening torque.
Tightening torque:
Oil filter union
19.9-24.3 lbs·ft
(
27-33 N·m
)
-
Place a new gasket on one of the crankc ase
halves, preferably on the transmission side,
together with the locating dowels.
-
Lubricate the main bearings and insert the
crankshaft in the transmission side crankcase
half.
-
Re-assemble the two crankcase halves.
Note:
Take care that the threaded end of the
crankshaft does not damage the main bearing.
-
Place the shim adjusting washers in their
original position.
-
Fit the eleven screws and tighten them to the
prescribed torque.
Tightening torque:
Half crankcase coupling screws
8.1-9.6 lbs·ft
(
11-13 N·m
)
Note:
Remove any remains of the old gasket from
the crankcase and cylinder mating surfaces in
order to ensure proper seals.
-
Lubricate the flywheel-side oil seal.
-
Using the appropriate special tool, fit the oil
seal.
Recommended tools and equipment:
Punch for oil seal
020425Y
Note:
Not using the special tool can lead to the oil
seal being fitted at the wrong depth, thereby
preventing it from working properly.
-
Fit a new O-ring on the oil sieve and lubricate it.
-
Re-ft the oil seal to the engine with the oil drain plug and tighten to the specified
tightening torque.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
