162
-
Remove the camshaft.
-
Remove the rocker pin by pushing it through
from the flywheel side.
-
Remove the rockers, together with their spring
washers.
Note:
Mark the position of the rockers in order to
prevent the reversal of the inlet and outlet rockers
on reassembly.
10.10.13 Removing the Cylinder Head
-
Remove the spark plug.
-
Remove the two screw fasteners on the outside
of the cylinder head, shown in the figure.
-
Loosen the four cylinder head securing nuts in
two or three stages, following a diagonal
crosswise sequence.
-
Remove the cylinder head, the two locating
dowels and the cylinder head gasket.
Note:
If necessary, the cylinder head can be
removed as a complete assembly, together with
camshaft, rocker pin and camshaft support.
Furthermore, the cylinder head can be removed
without completely removing the timing chain,
together with the tensioner.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...