137
-
Install the three 15mm bearings using the
specific tools.
Specific equipment and tools:
Handle
020376Y
(
42
×
47mm
) adapter
020359Y
0.585 in (
15mm
) guide
020412Y
Note:
The 42mm side of adapter 020359Y must
face the bearing.
Note:
Before installing the bearings onto the cover, ensure that this is suitably supported by
means of the recommended column kit.
Specific equipment and tools:
Column kit
020489Y
-
Replace the driven pulley axle bearing using the
modular punch as shown in the figure.
Note:
If the bearing is of the asymmetric ball
containment type, place it as shown in the figure.
Specific equipment and tools:
Handle
020376Y
(
42
×
47mm
) adapter
020359Y
0.787 in (
20mm
) guide
020363Y
-
Replace the Snap ring.
Note:
To install the bearings onto the engine crankcase it is necessary to ensure that the
crankcase is supported in such a way to allow the bearings to be placed vertically.
10.7.34
Fitting the Wheel Axle Bearing on the Cover
-
Place the hub cover on an appropriate wooden
surface.
-
Heat the cover using the hot air gun.
-
Fit the wheel axle bearing onto the cover using
the specific tools.
Specific equipment and tools:
Hot air gun support
020150Y
Hot air gun
020151Y
Handle
020376Y
2.047
×
2.165 in (
52
×
55mm
) adapter
020360Y
1.181 in (
30mm
) guide
020483Y
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
