152
1
Oil vapors to the air filter
6
Oil filler
2
Rocker cover
7
Oil level in sump
3
Crankshaft
8
Oil pump
4
Oil blow-by valve
9
Oil filter cartridge
5
Low oil pressure sensor
10
Net oil filter
10.10.1
Checking the Oil Pressure
-
After removing the flywheel cover as described
in the “Flywheel” chapter (p. 141), detach the
electrical connection of the oil low pressure
switch and remove the switch.
-
With the engine idling at 1,650 rpm and the
engine oil at temperature of ~194
°
F (
~90
°
C
),
check that the oil pressure is in the range 0.5-
1.2 atm.
-
With the engine running at 6,000 rpm and the
engine oil at a temperature of. ~194
°
F (
~90
°
C
),
check that the oil pressure is in the range 3.2-
4.2 atm.
-
After completing the check, remove the specific
tools fitted to the engine, refit the low oil
pressure switch, with its washer, and tighten it
with the prescribed torque. Then fit the flywheel
cover.
-
If abnormal pressures are found, check in the
following order, the oil filter, the by-pass, the oil
pump and the crankshaft seals.
Specific tools and equipment:
Oil pressure gauge
020193Y
Pressure gauge connection
020434Y
Multimeter with temperature probe
020331Y
Note:
Before carrying out the check, ensure that
the oil is at the right level and that the oil filter is in
good condition.
Min.
allowable pressure:
Oil pressure
3.2 atm @ 6,000rpm
Tightening torques:
(Also applies to inspection joint)
8.8-10.3 lbs·ft
(
12-14 N·m
)
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
