170
10.10.23 Fitting the Piston Rings
-
Place the oil scraper ring spring on the piston.
-
Install the scraper ring keeping the opening
opposed to the spring junction and with the
word “TOP” facing upwards. In any case, the
chamfering must be arranged towards the
piston.
-
Fit the middle piston ring with the identification
letter facing the crown of the piston. The
tapered side of the middle piston ring should
always be facing the crown of the piston.
-
The top piston ring with the word “TOP” or the
reference mark facing the crown of the piston.
Note:
In order to improve the bedding in of the
rings, the surfaces on the top two piston rings are
angled to give a conical section of contact.
Note:
Offset the piston ring gaps on the three
rings by 120
°
to each other, and lubricate the
components with engine oil.
10.10.24 Fitting the Cylinder
-
Fit the base gasket of the chosen thickness,
previously determined.
-
Using the fork support and the piston ring
retaining band. Install the cylinder as shown in
the figure.
Specific tools and equipment:
Piston fitting fork
020426Y
Piston ring retaining band
020393Y
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
