209
-
Replace the accelerator pump valves in the
following sequences:
Intake valve (A):
Spring
Sphere
Nozzle
Delivery valve (M):
Sphere
Spring
Nozzle
Note:
The delivery valve nozzle is provided with a
milling.
-
Check the seal on the screw by introducing a
small amount of fuel into the float bowl.
-
Re-fit the float bowl to the carburetor body,
using a new gasket and tightening the four
screws to the specified torque.
-
Check that the throttle rocker arm rotates
freely onto its seat.
Note:
Check that the gasket is inserted properly.
Note:
Avoid excessively loading the accelerator
pump rocker arm control.
-
Clean and blow the idle-speed flow screw.
-
Check that the screw is free from oxidation
and/or deformations.
-
Fit the spring onto the screw, as shown in the
picture.
-
Tighten the flow screw onto the carburetor body and adjust its final position by carrying
out an exhaust gas analysis.
-
Prepare the carburetor for adjustment with the screw loosened by two turns from its
closing position.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
