71
N
= Roll-over valve
O
= Union “
T
”
P
= Enviornment
Checking the CO Concentration
This test may be re quired when engine operation is irregular or while adjusting the idle.
The test must be carried out after washing all carburetor components and making sure that the
air filter is clean and the spark plug is in good condition.
-
Remove the side fairing and then the trans-
mission cooling air inlet duct so as to easily
reach the flow adjustment screw.
-
Remove the gas cap on the exhaust.
-
Using the original washer, install the exhaust
gas collection kit onto the exhaust.
-
Suitably orientate all the components.
-
Close the gas outlet terminal of the tool.
-
Start the engine and let it warm up until the
electric fan activates.
-
Stop the engine.
-
Disconnect the SAS (Secondary Air System)
check valve vacuum pipe from the ‘T’
connection shown in the figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
