203
-
Remove the idle-speed flow screw with O-ring,
washer and spring.
-
Remove the two fixing screws, the cover, the
spring and the cut -off device membrane.
Warning
- Do not attempt to remove components pressed into the carburetor body. These
include the fuel feed duct, the needle valve seat, the starter jet, the emulsion tube plug, the
accelerator jet, the air adjuster (minimum and maximum), the butterfly valve and the
butterfly valve control arm. The screw fasteners have been crimped after fitting and
removing them will damage the arm.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
