127
-
Using a curved-spout grease dispenser, lubricate
the driven pulley assembly with approximately
¼
oz. (
7 g
) of TUTELA MRM2 grease. Apply
grease to one of the holes in the bushing until it
comes out through the hole on the opposite side.
Note:
This operation is necessary to avoid the
presence of grease beyond the O-rings.
Recommended grease:
TUTELA MRM2
Note:
The lubrication of the servo-system can be carried either with the bearings installed or
during their replacement. It may be easier to proceed with the lubrication during overhaul.
10.7.18
Checking the Moving Driven Half-Pulley Spring
-
Measure the length of the moving driven half-
pulley spring, as shown in the figure.
Note:
The spring must be unloaded.
Standard dimension:
Spring length
4.84 in
(
123mm
)
Min. allowable dimension:
Spring length
4.65 in
(
118mm
)
10.7.19
Checking the Drive Belt
-
Ensure the drive belt shows no external signs of
damage, i.e. no cracks.
-
Measure the belt width as shown in the figure.
Standard dimension:
Belt width
0.8071±0.0078 in
(
20.50±0.20 mm
)
Min. allowable dimension:
Belt width
0.7600 in
(
19.5 mm
)
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
