Safety
We really do not want you to get hurt, so please follow these safety rules:
Avoid roadways, paths, or other areas that are used by motor vehicles.
Wear a helmet at all times.
Avoid large hills.
Avoid curbs, cobblestones, grates, and other rough or discontinuous
surfaces.
Read carefully the section of these instructions on braking, and become
comfortable braking on the rear tire and with the hand lever.
Never ride with more than one person on a scooter.
Never ride a scooter at dusk or at night.
Never ride a scooter in wet or icy conditions.
Ride in control at all times.
Don't stunt ride.
Before each use, verify that there are no loose or missing parts, and that the
brake is working properly.
WARNINGS:
Scooters are wheeled vehicles. Like bicycling, skateboarding, and in-line
skating, riding a scooter can be dangerous even under the best of circumstances.
Serious injury or even death is possible.
Always wear an ANSI or Snell approved helmet when riding your scooter.
Always keep the chinstrap securely buckled. Failure to wear an approved helmet
may result in serious injury or death.
Wet weather impairs traction, braking, and visibility. The risk of accident is
dramatically increased in wet conditions.
Riding at dusk, after dark, or at times of poor visibility is dangerous and can
result in serious injury or death.
Failure to properly tighten the handlebar quick-release lever may compromise
steering action, which could cause you to lose control and fall. Falling can cause
serious injury or even death. Push up and down on the handlebar to make sure
that the lever is tight
Unfolding
Pull out the locking pin from the hole in the steer support arm beneath the
deck.
Unfold the scooter so that the hole in the steer support arm aligns with the
holes in the frame that extend above the deck.
Re-insert the locking pin through these holes.
Loosen the "quick release" lever on the steering column.
Extend the handlebar to a comfortable height.
Tighten the quick release lever on the steering column to lock the handlebar
at the desired height. (If there is insufficient locking action, tighten the nut
on the quick release lever about one turn before clamping.)
Folding
Loosen the quick release lever on the steering column to unlock the
handlebar.
Slide the handlebar into the steering column.
Tighten the quick release lever on the steering column.
Pull out the locking pin from the holes in the frame extending above the
deck.
Fold the scooter so that the hole in the steer support arm is visible below the
frame rails underneath the deck.
Re-insert the locking pin through the hole in the steer support arm.
NOTE: A little bit of bicycle lubricant will facilitate insertion and removal of the
locking pin.
Copyright 2006, Xootr LLC. All rights reserved. Xootr is a registered trademarks of Xootr LLC.
Revision of July 2006
