Vertical Comdial DX-80, Technical Manual

Page: 24 / 322

O
VERVIEW
> P
ROGRAMMING A
N
EW
S
YSTEM
DX-80 Programming Manual
- 24 -
3. Assign the Day classification for the CO line.
4. Assign the Evening classification for the CO line.
5. Select the MOH source for the CO line.
6. Assign the dial type this CO line.
7. Assign the CO line type.
8. Enable/disable call abandon.
9. Set up privacy for this CO line.
10. Set up the CO ring type.
11. Assign the answer position for Day and Evening modes for this CO line.
12. Set up Time Switching.
13. Set up Pre-Defined Call Forward for this line.
14. Set up the PBX code for line group 1-8.
15. Set up the hunt method
16. Set up the alternate CO group.
17. Set up Fax detection.
Details on how to perform these tasks are included in Section 5, Programming CO Lines . The DX-80 provides
programmable features that allow you to establish these various settings.
1.3.3 SETTING UP CALL HANDLING
Next, set up how you want the DX-80 to handle calls. Perform the following steps.
1. Program conference calls.
2. Specify the CO flash time.
3. Specify the PBX flash time.
4. Specify the pause time.
5. Specify the ring abandon.
6. Set up the hold remind.
7. Select the exclusive hold time.
8. Establish the warning time.
9. Set the transfer intercom recall and transfer busy recall.
10. Set up hold recall.
11. Set up the dial wait time and dial delay.
12. Establish the dialing ratio.
13. Establish the start and end of the SLT hook flash.
14. Program auto redial.
15. Set up external call forward.
16. Set up conference talk time intervals and conference tones.
17. Set up the camp on interval.
18. Set up the alarm play intervals.
19. Enable/disable the hotel feature.
20. Enable/disable the system speed check.