Terumo BCT Quantum Cell Expansion System, Operator'S Manual

Page: 77 / 204

About Settings
Each task has multiple settings for each step of the task, including IC Inlet, IC Inlet Rate, IC Circulation
Rate, EC Inlet, EC Inlet Rate, EC Circulation Rate, Outlet, Rocker, and Stop Condition. These settings
determine what happens during each step of a task. You can modify the settings for some tasks. For those
tasks, the instructions in this operator’s manual include a table of settings for each step that lists the
factory default for each setting and the additional options for each setting.
For some tasks that have multiple steps, a setting in a step is dependent on the value entered for the same
setting in a previous step. For example, if you enter an IC Inlet Rate of 10 mL/min for step 1 of a task,
and the IC Inlet Rate setting for step 2 is dependent, the system automatically populates an IC Inlet Rate
of 10 mL/min for step 2. This operator's manual denotes dependent settings by listing one of the
following phrases in the settings table for the affected step:
•
Same as step 1
• Same as step 2
The highlighted row in Table 6-1 is an example of how this appears in a table of settings in this operator's
manual.
Table 6-1: Example of a dependent setting
Setting Factory Default Setting Options
IC Inlet Cell N/A
IC Inlet Rate 50 mL/min Same as step 1
IC Circulation Rate 0 mL/min N/A
EC Inlet None N/A
EC Inlet Rate 0 mL/min N/A
EC Circulation Rate 30 mL/min 10 to 300 mL/min
Outlet EC Outlet N/A
Rocker In Motion (−90°, −180°, 1 sec) In Motion (−180° to 270°, 0 to 3600 sec), Stationary (0°)
Stop Condition Empty Bag N/A
The following sections explain each setting and describe how to select those settings, which appear on
the Setup screen, shown in Figure 6-2.
Performing Tasks
6-4 Quantum
®
Cell Expansion System • Operator's Manual for Software Version 2.1