Studer Vista, Operating Instructions Manual

Page: 251 / 713

D950/Vista Digital Mixing System
Date printed: 05.08.03 SW V3.3
GC Operation 4-123
The typical Fader Start Trigger combination is:
•
Input selector, and
• Channel on (MUTE), and
• Fader (open).
You can also remove all assigned relays from the list by clicking on the
Remove all outputs button.
F Tip For a typical stereo source, such as a CD player, the same relay should be
configured for both the left and the right signal part, as shown in the ex-
ample above for D1 (relay
cd1 ) and D2 (relay cd2 ). This action ensures
that the CD player will start even if it is connected to two Mono Input
Channels, and only
one of the faders is opened.
4.7.6.3 Red Light Configuration
Generally, Red Light Outputs are relays installed within the Monitoring
frame. Usually only one relay is used for the global Red Light Signaling,
but several relays can be configured independently if more than one Studio
exists.
The Trigger conditions for a Red Light relay to be activated are fixed to
the following:
•
A Source configured for Red Light is patched to a Channel, and
• The Input Channel Input Selector is set to the above Source, and
• The Input Channel Fader is open, and
• The Input Channel ON (MUTE) is open, and
• The Input Channel is routed to at least one Master Bus, and
• The Master Channel Input Selector is set to the above Source, and
• The Master Channel Fader is open, and
• The Master Channel ON (MUTE) is open.
In other words, the audio signal has a fully open path from the Source to
the Master Channel output. If an Input Channel is routed to a group only,
then the Group has to be routed to a Master, etc., to fulfill the Trigger con-
ditions.
Multiple sources are usually configured to one single relay – they form a
logical OR. For instance, all Mic Inputs from the same room would be
configured to the same Red Light relay.