Sony MVS-8000X SystemMVS-7000X System, User Manual

Page: 555 / 706

USO
RESTRITO
Reset and Initialization (Initialize Menu) / Installation and Device Setup (Install/Unit Config Menu)
555
Ch
a
p
te
r 18
S
y
s
te
m
S
e
tu
p
(S
y
s
te
m
)
Reset and Initialization
(Initialize Menu)
To carry out a reset or memory initialization for a device,
use the System >Initialize menu.
•
Reset: Reset to state after powering on.
•
All Clear: Clear the memory, and carry out
initialization. The Network Config, System Config,
Format, and Start Up setup values are set by reference to
data stored in non-volatile memory, and the system
automatically starts up. It is not necessary to reset the
Date/Time settings.
For more details, see “Saving and Recalling Setup Data”
(page 553).
To display the Initialize menu
In the Engineering Setup menu, select VF1 ‘System’ and
HF5 ‘Initialize.’
The status area shows the current start-up mode settings.
Resetting the device and initializing
memory
Notes
When the MVS-7000X is reset, the MKS-7470X/7471X is
also reset at the same time.
1
In the status area of the System >Initialize menu, select
the device to which the settings are to apply.
2
In the <Initialize> group, select one of the following
modes.
Reset: Reset the device.
All Clear: Initialize memory.
3
Press [Execute].
A confirmation message appears.
4
Select [Yes].
Depending on the selection in step 2 , the following is
the result.
•
When you selected [Reset], a reset is applied to the
device causing it to be restarted in the start-up state.
•
When you selected [All Clear], all memory in the
device is cleared, including snapshots, keyframe
effects, setup, and so on, and the device returns to its
factory default settings. However, the Network
Config, Format, Start Up, and Date/Time settings
are not initialized.
Installation and Device
Setup (Install/Unit Config
Menu)
To install software or firmware in a device, use the System
>Install/Unit Config menu.
This installs the software and firmware in all devices
(including the DCU) connected to the Data LAN.
Notes
The MKS-7470X/7471X software is included in the MVS-
7000X software.
To display the Install/Unit Config menu
In the Engineering Setup menu, select VF1 ‘System’ and
HF6 ‘Install/Unit Config.’
The status area shows the version of the software and the
firmware installed in each device.
The following functions are available here.
Install: Automatically detects the software that can be
installed on each device, and installs the selected
software.
Detail Information: Gives details of the software and
firmware installed in each device.
Unit Config: Makes switcher processor settings and
changes the DME input/output signal format.
License: Makes the license valid or invalid.
Displaying installation details
In the System >Install/Unit Config menu, press [Detail
Information].
This accesses the Detail Information menu, and displays
the detailed information on the software and firmware
installed in the currently selected device.
Notes
When the MKS-7470X/7471X is selected, the Detail
Information menu cannot be opened.
Installing Software
1
Insert the memory card holding the software into the
memory card slot.
2
In the System >Install/Unit Config menu, press
[Install].
The Install menu appears; the status area shows the
following information.