Sony MVS-8000X SystemMVS-7000X System, User Manual

Page: 178 / 706

USO
RESTRITO
178
Wipe Snapshots
1
In the M/E-1 Flexi Pad control block, press the
[WIPE] button.
This switches the Flexi Pad control block to wipe
snapshot mode.
2
In the memory recall section, press the [PTN NO.]
button.
This switches the Flexi Pad control block to wipe
pattern number recall mode.
3
Use the buttons in the memory recall section to enter
the pattern number consisting of up to three digits, and
press the [ENTR] button.
The entry is confirmed, and now the numeric display
shows the pattern number (see page 357) .
Ch
a
p
te
r 5
W
ip
e
s
WIPE button
UNDO button
Flexi Pad control block (simple type)
Numeric
display
Memory
recall buttons
•
If you carry out a pattern mix, and both the main
pattern and sub pattern are selected, then the
memory recall button shows the main pattern.
The pattern appears on the button you pressed, which
lights yellow.
The numeric display shows the number of the
corresponding pattern.
It is also possible to display the register name using a
Setup menu.
For details, see “Operation Settings (Operation
Menu)” in Chapter 19 (Volume 2).
Meaning of the state of buttons
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
Lit yellow: The most recently recalled register.
Selecting a wipe pattern in the Flexi Pad
control block
To select a pattern with a standard type Flexi Pad control
block, use the following procedure. It is not possible to
select a wipe pattern with a simple type Flexi Pad control
block.
Canceling the saving of a wipe snapshot
To cancel the saving of a wipe snapshot immediately after
performing it, hold down the [STORE STATS] button, and
press the [UNDO] button.
The [STORE STATS] button changes from amber to
green.
Notes
On a simple type Flexi Pad control block, it is not possible
to cancel the saving of a wipe snapshot.
Saving a wipe snapshot
1
Make the wipe settings that you want to save.
Make any modifier settings required (see page 166) .
2
In the Flexi Pad control block, hold down the [WIPE]
button, and press the memory recall button
corresponding to the register in which you want to
save.
Notes
•
If you press a button which is lit orange or yellow,
the existing contents of the register are overwritten.
Recalling a wipe snapshot
1
In the Flexi Pad control block, press the [WIPE]
button.
This switches the Flexi Pad control block to the wipe
snapshot mode.
2
Press the memory recall button for the register from
which you want to recall the wipe snapshot.
The button lights, and the saved wipe snapshot is
recalled. At this point, the numeric display shows the
pattern number or register name.
Canceling the recall of a wipe snapshot
To cancel the recall of a wipe snapshot, press the [UNDO]
button.
Deleting a wipe snapshot
When the [WIPE] button is lit in the Flexi Pad control
block, hold down the [STORE STATS] button and press
the memory recall button for the register in which you
want to delete the wipe snapshot.