Sony MVS-8000X SystemMVS-7000X System, User Manual

Page: 144 / 706

USO
RESTRITO
144
Key Adjustments (Key Control Block)
Knob Parameter Adjustment Setting values
1 Luminance Color 2
luminance
0 to 100
2 Saturation Color 2
saturation
0 to 100
3 Hue Color 2 hue 359 to 0
4 Soft Edge softness 0 to 100
Ch
a
p
te
r 4
K
e
y
s
When [Mix Color] is on, and
the [MORE] button is lit green
Key Adjustments (Key
Control Block)
This section describes the various key adjustments
provided by the control panel key control block.
When using the key fill bus signal: Press the [MATTE
FILL] button, turning it off.
To select the key fill signal, use the key 1 or key 2 row
buttons in the cross-point control block.
For the CCP-6224/6324 Control Panel, it is necessary
to set the [AUX CTRL] button to Off in order to exit
the AUX panel-less function
(see page 92) .
Selecting Key Source
•
To use the key source paired with the key fill signal
selected on the key fill bus, press the [AUTO SEL]
button, turning it on. The pairing of the cross-point
buttons for key fill and key source is carried out in the
Setup menu.
For details, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 19 (Volume 2).
•
To select the key source independently of the key fill
signal selected on the key fill bus and paired with the key
source, hold down the [SPLIT] button, turning it on, then
press the desired key 1 or key 2 row button in the cross-
point control block.
•
To use as key source the same signal as the key fill signal
selected on the key fill bus, select the SELF mode by
pressing the [AUTO SEL] button and [SPLIT] button
simultaneously so that both are off. When chroma key is
selected as the key type, select the SELF mode.
Key Edge Modifications
To apply a modification to the key edge (see page 124) ,
press one of the edge type selection buttons in the key
control block.
[BDR] button: border
[DROP BDR] button: drop border
[SHDW] button: shadow
[OUTLINE] button: outline
[EMBOS] button: emboss
The pressed button lights green, and you can now adjust
the parameters with the knobs. The display beside each
knob shows the first letter of the parameter name and the
three-digit setting value.
Setting the border parameters
When the [BDR] button is lit green, the parameter settings
depend on the key type and whether the separate edge
function is active. To activate the separate edge function,
press [Separate Edge], setting it on, in the Edge menu for
the key.
Separate edge off
Knob Parameter Adjustment Setting values
1 Width Border width
0 to 8
a)
(0 to 100)
b)
4 Density Border density 0 to 100
a) In the “4H mode” and when [Fine Key] (page 135) is on, the setting value
range is 0 to 4.
b) When a wipe pattern key or key wipe pattern key is selected as the key type
Separate edge on
The border width settings can be made independently for
left, right, top, and bottom sides. The separate edge
function is only available when luminance key, linear key,
or chroma key is selected as the key type.
Knob Parameter Adjustment Setting values
1 Top Top edge width
0 to 8
a)
2 Left Left edge width
0 to 8
a)
3 Right Right edge width 0 to 8
a)
4 Bottom Bottom edge width 0 to 8
a)