6.7.2
Continuing program from search target
Press the "CYCLE START" key twice to continue the program from the desired position.
● The first CYCLE START outputs the auxiliary functions collected during the search. The
program is then in the Stop state.
● Before the second CYCLE START, you can use the "Overstore" function to create states
that are required, but not yet available, for the further program execution.
If the set position is not to be approached automatically after the program start, you can also
traverse the tool manually from the current position to the set position by changing to JOG
mode for the REPOS function
6.7.3
Simple search target definition
Requirement
The program is selected and the controller is in Reset mode.
Procedure
1.
Press the "Block search" softkey.
2.
Place the cursor on a particular program block.
- OR -
Press the "Find text" softkey, select the search direction, enter the
search text and confirm with "OK".
3.
Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into ac‐
count.
The current block will be displayed in the "Program" window as soon as
the target is found.
4.
If the located target (for example, when searching via text) does not
correspond to the program block, press the "Start search" softkey again
until you find your target.
Press the <CYCLE START> key twice.
Processing is continued from the defined position.
Machining the workpiece
6.7 Starting machining at a specific point
Turning
166
Operating Manual, 06/2019, A5E44903486B AB
