The actual value display of the positions can also refer to the SZS coordinate system (settable
zero system). However the positions are still output in the Work.
The SZS coordinate system corresponds to the Work coordinate system, reduced by certain
components ($P_TRAFRAME, $P_PFRAME, $P_ISO4FRAME, $P_CYCFRAME), which are
set by the system when machining and are then reset again. By using the SZS coordinate
system, jumps into the actual value display are avoided that would otherwise be caused by the
additional components.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Maximize display
Press the ">>" and "Zoom act. val." softkeys.
Display overview
Display
Meaning
Header columns
Work/Machine
Display of axes in selected coordinate system.
Position
Position of displayed axes.
Display of distance-to-go
The distance-to-go for the current NC block is displayed while the
program is running.
Feed/override
The feed acting on the axes, as well as the override, are displayed
in the full-screen version.
REPOS offset
The distances traversed in manual mode are displayed.
This information is only displayed when you are in the "REPOS"
function.
Collision avoidance
Collision avoidance is activated for JOG, MDI and AUTO
modes.
Collision avoidance is deactivated for JOG, MDI and AU‐
TO modes.
Footer
Display of active work offsets and transformations.
The T, F, S values are also displayed in the full-screen version.
See also
Zero offsets (Page 117)
Set collision avoidance (Page 714)
Introduction
2.4 User interface
Turning
46
Operating Manual, 06/2019, A5E44903486B AB
