Parameter
Meaning
P:
Number of subprogram repetitions
If a subprogram is performed several times, you can enter the number of the
pass here at which processing is to be continued
Line:
Is automatically filled for an interruption point
Type
" " search target is ignored on this level
N no. Block number
Label Jump label
Text string
Subprg. Subprogram call
Line Line number
Search target
Point in the program at which machining is to start
6.7.7
Block search mode
Set the desired search variant in the "Search Mode" window.
The set mode is retained when the control is shut down. When you activate the "Search"
function after restarting the control, the current search mode is displayed in the title row.
Search variants
Block search mode
Meaning
With calculation
- without approach
In order to be able to approach a target position in any circumstance (e.g. tool
change position).
The end position of the target block or the next programmed position is ap‐
proached using the type of interpolation valid in the target block. Only the axes
programmed in the target block are moved.
Note:
If machine data 11450.1=1 is set, the rotary axes of the active swivel data
record are pre-positioned after the block search.
With calculation
- with approach
It is used to be able to approach the contour in any circumstance.
The end position of the block prior to the target block is found with <CYCLE
START>. The program runs in the same way as in normal program process‐
ing.
Note:
This block search mode should only be used in exceptional cases if machin‐
ing was directly interrupted at the workpiece - and machining is to directly
continue at the workpiece again.
For a ShopTurn program, this block search mode can only be performed on
G code blocks.
If possible, the block search mode "with calculation - without approach"
should be used.
Machining the workpiece
6.7 Starting machining at a specific point
Turning
Operating Manual, 06/2019, A5E44903486B AB
169
