Interface and Menus
39 of 132
Publication S177E V2.0 Issue 12/04
8.5.1
Master Station Commands
1>Reset Loop 9>ESD
2>Start Config Mode
3>Change Master
4>Diagnostic 5>Setup
This screen provides commands and options for the master station itself. The PIN number may require
to be entered before some functions are permitted. Config Mode forces the selected serial port to a
fixed setup so that MasterTools utility can communicate via that port. The RS232/RS485 settings must
be made independently. (MasterTools is the Rotork supplied utility used to read and write setup and
tag data with a PC.)
Commands available:
-
Command to re-configure loop. This should be used after a loop fault has
been corrected
-
Start or stop Configuration Mode. A port selection screen appears to set the
comms port to use with the MasterTools utility.
-
(Hot Standby systems only) Relinquish control and allow the other unit to
take over.
-
Go to diagnostic menu
-
Go to setup menu
-
Send ESD command to all field units. This option is only displayed if the
Keypad ESD has been enabled.
-
Return to previous menu
After pressing either of the command keys 1, 3 or 9, a confirmation message screen appears asking
whether you wish to send the command (e.g. after pressing 1, the Reset Loop key, the following will
appear)
Reset Loop Command
LOAD to confirm
CLEAR to cancel
-
Confirms the command previously selected and executes it.
-
Cancels the command previously selected.
1
2
4
5
9
MENU
LOAD
CLEAR
3
