Remote Control Commands
R&S
®
SMF100A
590
Operating Manual 1167.2319.02 ─ 12
Improper use can destroy the assembly
The respective hardware assembly responds directly to the
:TEST:DIRect
command;
any safety mechanisms are bypassed. The command is intended for servicing purpo-
ses and should be used only by the Rohde
&
Schwarz service personnel.
:TEST<hw>:DIRect
<HW_assembly>,<subadress>,<hex data string>
:TEST<hw>:DIRect?
<HW_assembly>,<subadress>
The respective hardware assembly responds directly to the command; any safety
mechanisms are bypassed. This function is only available via remote control.
Example:
TEST:DIR 'SSYN',0,#H12345678
TEST:DIR? 'SSYN',0
Response:
#H12345678
7.17 TRIGger Subsystem
The
TRIGger
system contains the commands for selecting the trigger source for the
RF and LF sweep. The trigger input connectors are configured in the
SOURce:INPut
subsystem.
The trigger system of the R&S
SMF is a simplified implementation of the SCPI trigger
system. The
TRIGger
system differs from the SCPI system as follows:
●
No
INITiate
command; the instrument behaves as if
INITiate:CONTinuous
ON
were set.
●
Under
TRIGger
several sweep subsystems exist.
Other commands associated with the trigger system of the R&S
SMF can be found in
the modulation and RF signal subsystems.
TRIGger<hw>
●
Suffix
TRIGger<1|2>
is not permitted
Table 7-2: Cross-reference between the manual and remote control
R&S name
SCPI name
Command under manual con-
trol
AUTO
IMMediate
"Auto" mode
SINGle
BUS
"Single" mode.
TRIGger Subsystem
