Chapter 5: Using the EMX
82
For Raritan's DPX water sensors, the Normal state must be set to
Normally Open (N.O). The following is the correct LED behavior
based on proper dip switch settings.
LED
Sensor state
Off
No water detected
Lit Water
detected
Reset Button
The reset button is located inside a small hole which is labeled RESET.
The EMX can be reset to its factory default values using this button when
a serial connection is available. See
Resetting to Factory Defaults
(on
page 477).
Without the serial connection, pressing this reset button only restarts the
EMX software.
Beeper
The EMX includes an internal beeper, which can issue an audible alarm.
Note that the beeper does NOT sound an alarm unless an event rule
involving the internal beeper has been created and turned on the internal
beeper accordingly. See
Event Rules and Actions
(on page 187).
Tip: You can remotely check this beeper's state via the web interface.
See
Checking the Internal Beeper State
(on page 148).
Summary of Contents for EMX2-888
