Chapter 4: Connecting External Equipment (Optional)
56
An RJ-12 to RJ-45 adapter is recommended to connect a DPX or
DPX2 sensor package to DPX3-ENVHUB4.
In the following diagrams, the sensor package in "green" can be
replaced by a DPX2 sensor package. The sensor package in "blue"
can be one DPX2, DPX3 or DX sensor package.
An RJ-12 to RJ-45 adapter cable MUST be used for connecting the
DPX3-ENVHUB4 to the EMX.
This section only illustrations the following three combinations, but
actually there are tens of different combinations by using the
DPX3-ENVHUB4 sensor hub.
Summary of Contents for EMX2-888
