Appendix I: Additional EMX Information
541
Connecting Contact Closure Sensors to OLD EMX2-888
Follow the steps below to connect Raritan's or third-party contact closure
detectors/switches to the termination points labeled CONTACT SENSOR
if your EMX is the old EMX2-888 with a built-in spring-loaded terminal
module.
It is not guaranteed that all third-party detectors/switches are compatible
with the EMX. You need to test the compatibility after installing them.
Note: If you are using an EMX2-888 with a removable terminal module,
see
Connecting Contact Closure Sensors to EMX2-888
(on page 77).
To connect sensors to old EMX2-888 contact closure terminals:
1. Strip the insulation around 12 mm from the end of each wire of
discrete detectors/switches.
2. Press and hold down the tiny rectangular buttons above the
termination points.
Note: Each button controls the spring of each corresponding
termination point.
3. Fully insert each wire of both detectors/switches into each
termination point.
Plug both wires of a detector/switch into the two termination
points to the left.
Plug both wires of the other detector/switch into the two
termination points to the right.
Summary of Contents for EMX2-888
