Chapter 8: Using the Command Line Interface
423
Naming an Asset Sensor
This command syntax names or changes the name of an asset sensor
connected to the EMX device.
config:#
assetStrip <n> name "<name>"
Variables:
<n> is the number of the FEATURE port where the selected asset
sensor is physically connected. For the EMX device with only one
FEATURE port, the number is always 1.
<name> is a string comprising up to 32 ASCII printable characters.
The <name> variable must be enclosed in quotes when it contains
spaces.
Specifying the Number of Rack Units
This command syntax specifies the total number of rack units on an
asset sensor connected to the EMX device.
config:#
assetStrip <n> numberOfRackUnits <number>
Note: For the Raritan asset sensor, a rack unit refers to a tag port.
Variables:
<n> is the number of the FEATURE port where the selected asset
sensor is physically connected. For the EMX device with only one
FEATURE port, the number is always 1.
<number> is the total number of rack units available on the
connected asset sensor. This value ranges from 8 to 64.
Summary of Contents for EMX2-888
