Raritan EMX2-888, User Manual

Page: 29 / 568

Chapter 3: Installation and Configuration
15
Wi-Fi LAN adapters Supported 802.11
protocols
Zyxel NWD271N B/G
Edimax EW-7722UnD A/B/G/N
TP-Link TL-WDN3200 v1 A/B/G/N
Raritan USB WIFI A/B/G/N
Note: To use the Edimax EW-7722UnD or Raritan USB WIFI wireless
LAN adapter to connect to an
802.11n
wireless network, the handshake
timeout setting must be changed to 500 or greater, or the wireless
connection will fail.
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN
configuration of your EMX matches the access point. The following is the
wireless LAN configuration that the EMX supports.
 Network type: 802.11 A/B/G/N
 Protocol: WPA2 (RSN)
 Key management: WPA-PSK, or WPA-EAP with PEAP and
MSCHAPv2 authentication
 Encryption: CCMP (AES)
Important: Supported 802.11 network protocols vary according to the
wireless LAN adapter being used with the EMX. See
USB Wireless LAN
Adapters (on page 14).
Initial Network Configuration via CLI
After the EMX is connected to your network, you must provide it with an
IP address and some additional networking information.
This section describes the initial network configuration via a serial
RS-232 or USB connection. To configure the network settings using the
web interface, see
Modifying the Network Configuration
(on page
110).
To configure the EMX device:
1. On the computer connected to the EMX, open a communications
program such as HyperTerminal or PuTTY.
2. Select the appropriate COM port, and set the following port settings:
 Bits per second = 115200 (115.2Kbps)
 Data bits = 8