Raritan EMX2-888, User Manual

Page: 436 / 568

Chapter 8: Using the Command Line Interface
422
USB-Cascading Configuration Commands
A USB-cascading configuration command begins with
cascading
. You
can set the cascading mode on the master device.
Note: You CANNOT change the cascading mode on slave devices.
Configuring the Cascading Mode
This command determines the cascading mode.
config:# cascading mode <mode>
Variables:

<mode> is one of the following cascading modes:
Mode Description
bridging The network bridging mode, where each
cascaded device is assigned a unique IP
address.
portForwarding The port forwarding mode, where every
cascaded device in the chain shares the
same IP address, with diverse port
numbers assigned.
Asset Management Commands
You can use the CLI commands to change the settings of the connected
asset sensor (if any) or the settings of LEDs on the asset sensor.
Asset Sensor Management
An asset sensor management configuration command begins with
assetStrip
.